Starter Switch Positions - SMART for two coupé Operator's Manual

Closing: Swivel the rear soft top down-
X
wards to close.
Pull soft top down.
X
Pull release levers :, located to the left
X
and right of the retaining clip, down-
wards.
Make sure the rear soft top is correctly
X
locked in place on both sides.
Closing the tailgate on the cabriolet
G WARNING
To prevent possible personal injury,
always keep hands and fingers away from the
cargo compartment opening when closing
the tailgate. Be especially careful when
small children are around.
! When closing the tailgate, you must
first close the rear soft top. Otherwise
you might break the release levers of the
rear soft top.
Swivel the tailgate upwards to close. Let
X
the tailgate lock into place.
G WARNING
When leaving the vehicle, always remove the
key from the starter switch, take it with
you, and lock the vehicle. Do not leave chil-
dren unattended in the vehicle, or with
access to an unlocked vehicle. A child's
unsupervised access to a vehicle could
result in an accident and/or serious per-
sonal injury.

Starter switch positions

Starter switch positions
Starter switch
g For removing key
1 Ignition (power supply for all elec-
trical consumers) and driving posi-
tion
2 Starting the drive system
i
When you switch on the ignition, the
indicator and warning lamps (except
low‑beam headlamp indicator lamp,
high‑beam headlamp indicator lamp, and
turn signal indicator lamps unless acti-
vated) in the instrument cluster come on.
The indicator and warning lamps (except
low‑beam headlamp indicator lamp,
high‑beam headlamp indicator lamp, and
turn signal indicator lamps if activated)
will go out when the drive system is run-
ning. This indicates that the respective
systems are operational.
i
When you start the drive system,
appears in the multifunction display.
The warning and indicator lamps will go
out.
The pointer of the power gauge moves
from "OFF" to "0" (
READY READY
page 81).
Y
Z
57