SMART for two coupé Operator's Manual page 184

Replacing bulbs
182
Replacing bulbs for front lamps
Before you start to replace a bulb for a
front lamp, do the following first:
Turn the exterior lamp switch to position
X
$ ( page 64).
Y
Switch off the ignition.
X
Open the service flap (
X
Left headlamp, (right headlamp in reverse)
Parking and side marker lamp bulb
Removing:
X
Driver's side: Turn bulb socket ? toward
the outside.
Passenger side: Turn bulb socket ?
toward the outside.
Pull bulb socket ? out of the headlamp
X
housing.
Pull the bulb out of bulb socket ?.
X
Installing: Insert the new bulb into bulb
X
socket ?.
Insert bulb socket ? into the headlamp
X
housing.
Driver side: Turn bulb socket ? toward
X
the inside.
Passenger side: Turn bulb socket ?
toward the inside.
Low‑beam headlamp bulb
Removing: Take off low‑beam headlamp
X
cover =.
Detach the electrical connector.
X
page 123).
Y
Bend the retainer spring end down and
X
forward until it unclips. Fold the
retainer spring back.
Pull the bulb out of the headlamp hous-
X
ing.
Installing: Insert the new bulb into the
X
headlamp housing.
Fold the retainer spring forward.
X
Bend the retainer spring end forward
X
then up and back to clip in.
Attach the electrical connector.
X
Reinstall low‑beam headlamp cover =.
X
High‑beam headlamp bulb
Removing: Take off high‑beam headlamp
X
cover ;.
Detach the electrical connector.
X
Tilt the bulb socket down and pull it out.
X
Pull the bulb out of the bulb socket.
X
Installing: Insert the new bulb into the
X
bulb socket.
Fit the bulb so that the retaining lug of
X
the base plate is pointing up.
Press the bulb into the bulb socket until
X
it is fully engaged.
Attach the electrical connector.
X
Reinstall high‑beam headlamp cover ;.
X
Front turn signal lamp bulb
Removing: Turn bulb socket : counter-
X
clockwise by a quarter of turn and pull it
out of the headlamp housing.
Press gently onto the bulb and turn it
X
counterclockwise.
Pull the bulb out of bulb socket :.
X
Installing: Insert the new bulb into bulb
X
socket :.
Press gently onto the bulb and turn it
X
clockwise.
Insert bulb socket : into the headlamp
X
housing.