SMART for two coupé Operator's Manual page 94

Control system
92
Briefly press the OK button on the control
X
lever.
Press and hold the control switch on the
X
control lever up or down until the "Air
conditioning before start" function is
activated or deactivated.
Briefly press the OK button on the control
X
lever.
Press and hold the control switch on the
X
control lever up or down until the "Air
conditioning before start" function is
activated or deactivated.
Briefly press the OK button on the control
X
lever.
The new departure time is stored and
activated.
The "Air conditioning before start"
function is activated or deactivated.
Starting the charging process of the
high‑voltage battery immediately
This function allows you to start the charg-
ing process immediately. The charging
process begins as soon as the charging
cable is connected.
i
The charging process also begins when
you insert the charging cable into the
vehicle's power socket. However, this is
only the case if you have not made any
departure time settings.
Information on the charging process can
be found on (
Y
Press and hold the control switch on the
X
control lever up or down until the
Instant Charge Instant Charge
multifunction display.
Briefly press the OK button on the control
X
lever.
The charging process is started as soon
as the charging cable is connected.
i
When you call up the
menu, the "Air conditioning before
start" function is not available.
page 115).
menu appears in the
Instant Charge Instant Charge
Setting the maximum charge current
G WARNING
When connected to a power supply socket, a
high electrical load during the charging
process can lead to overheating of the
external power supply. There is a risk of
fire.
Check the maximum permissible charge
current on site before you begin the charg-
ing process. Contact an authorized electric
drive smart center should you require
assistance. If necessary, adjust the set-
tings of your vehicle.
You can limit the charge current of the
high‑voltage battery. This can protect the
power supply from overloading. You can set
the limit either on the control unit of the
charging cable or via the control system.
The preset standard value is "Max". This
corresponds to the maximum available
charge current of the power supply.
Check the maximum permissible charge
current for the respective power supply
socket before charging the high‑voltage
battery.
The following values are available for
selection: 8 A, 12 A, Max. The last value set
remains stored until a change is made.
Press and hold the control switch on the
X
control lever up or down until the
Charge Current Charge Current menu appears in the
multifunction display.
Briefly press the OK button on the control
X
lever.
Press and hold the control switch on the
X
control lever up or down until the
desired amperage is selected.
Briefly press the OK button on the control
X
lever.
The selected amperage is set.
i
If differing values are set on the charg-
ing cable and the control system, the
high‑voltage battery is charged using
the lowest value.