2
Hardware Installation
•
Line-in Jack (Light Blue - CN6)
This jack is used to connect any audio devices such as Hi-fi set,
CD player, tape player, AM/FM radio tuner, synthesizer, etc.
•
Mic-in Jack (Pink - CN8)
This jack is used to connect an external microphone.
Front Audio
The front audio connector (J6) allows you to connect to the
speaker-out and mic-in jacks that are at the front panel of your
system. Using the speaker-out and mic-in jacks will disable the rear
audio's speaker-out and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J2 prior to
connecting the front audio cable connector. Make sure pin 1 of the
cable connector is aligned with pin 1 of J2. If you are not using this
connector, make sure to replace the jumper caps back to their
original pin locations.
Driver Installation
Install the "Audio Drivers". Refer to chapter 4 for more information.
44
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.