DFI G4V100-P User Manual page 55

2.6.8 Wake-On-LAN Connector
Your LAN card package should include a cable. Connect one end of
the cable to the wakeup header on the card and the other end to
location J12 on the system board. The network will detect Magic
Packet and assert a wakeup signal to power-up the system. Refer to
the add-in card's manual for details. Note: Your LAN card must
support the remote wake up function.
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
BIOS Setting
To use the Wake-On-LAN function, you must enable the "Resume
On LAN" field in the Power Management Setup submenu of the
BIOS.
Hardware Installation
Ground
+5VSB WOL
!
1
2
3
55