DFI G4V100-P User Manual page 52

2
Hardware Installation
Connecting the IDE Disk Drive Cable
Install one end of the IDE cable into IDE 1 (J21) or IDE 2 (J20) on
the system board and the other connectors to the IDE devices.
Adding a Second IDE Disk Drive
When using two IDE drives, one must be set as the master and the
other as the slave. Follow the instructions provided by the drive
manufacturer for setting the jumpers and/or switches on the drives.
The system board suppor ts Enhanced IDE or ATA-2, ATA/33,
ATA/66 and ATA/100 hard drives. We recommend that you use
hard drives from the same manufacturer. In a few cases, drives from
two different manufacturers will not function properly when used
together. The problem lies in the hard drives, not the system board.
BIOS Setting
Enable or disable the onboard IDE in the Integrated Peripherals
submenu ("Intel OnChip IDE Device" section) of the BIOS. Refer to
chapter 3 for more information.
52
Note:
Refer to your disk drive user's manual for information about
selecting proper drive switch settings.
Important:
If you encountered problems while using an ATAPI CD-ROM
drive that is set in Master mode, please set the CD-ROM drive
to Slave mode. Some ATAPI CD-ROMs may not be recognized
and cannot be used if incorrectly set in Master mode.