DFI G4V100-P User Manual page 78

3
BIOS Setup
KB Power On Password
Move the cursor to this field and press <Enter>. Enter your
password. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press <Enter>.
The power button will not function once a keyboard password has
been set in this field. You must type the correct password to power-
on the system. If you forgot the password, power-off the system and
remove the battery. Wait for a few seconds and install it back
before powering-on the system.
KB Power On Hot Key
This field is used to select a function key that you would like to use
to power-on the system.
Onboard FDC Controller
Enabled
Disabled
Onboard Parallel Port
378/IRQ7, 3BC/IRQ7, 278/IRQ5 Selects the I/O address and
Disabled
Parallel Port Mode
The options are SPP, EPP, ECP and ECP+EPP. These apply to stand-
ard specifications and will depend on the type and speed of your
device. Refer to your peripheral's manual for the best option.
SPP
Allows normal speed operation but in one direction only.
"ECP (Extended Capabilities Port)"
Allows parallel port to operate in bidirectional mode and at a
speed faster than the normal mode's data transfer rate.
"EPP (Enhanced Parallel Port)"
Allows bidirectional parallel port operation at maximum speed.
78
Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
IRQ for the onboard parallel port.
Disables the onboard parallel port.