Indicator Table
Status Indicators
The UPS provides both visual and audible status indicators. Visual indicators consist of
three LEDs to represent the following conditions:
On utility power operation
On battery power operation
UPS fault/alarm
LED Indicator Table
On Utility (AC mode)
On Battery (backup mode)
Low Battery
Fault/Output Short
Overload/Check Battery
LED Audible Alarm Table
On Battery (backup mode)
Low Battery
Overload
Replace Battery
Fault or output short circuit
Battery over charge
Battery Replacement Procedure:
1.
Batteries must be replaced with identical type.
2.
Disconnect UPS system from power source
3.
Open battery door.
4.
Disconnect used battery. Connect new battery. (It is important that connectors be
firmly attached to new batteries.
5.
Close battery door.
6.
Properly recycle used battery.
UserÊs Manual 350-1500VA
Green Lighting
Yellow Lighting
Yellow Flashing
Red Lighting
Red Flashing
Sounding every 5 seconds
Sounding (two beeps) every 5 seconds
Sounding every 0.5 seconds
Sounding (three beeps) every 30 seconds
Continuous sounding
Sounding (three beeps) every 5 seconds
9