Indicator Table; Status Indicators; Led Indicatortable; Led Audible Alarmtable - Eaton Powerware 5110 User Manual

Indicator table

Status Indicators

The UPS provides both visual and audible status indicators. Visual indicators consist of
three LEDs to represent the following conditions:
• On utility power operation
• On battery power operation
• UPS fault/alarm
LED Indicator Table
On Utility (AC mode)
On Battery (Backup mode)
Low Battery
Fault/Output Short
Overload/Check Battery
LED Audible Alarm Table
On Battery (Backup mode)
Low Battery
Overload
Replace battery
Fault or output short circuit
Battery over charge

Battery replacement procedure:

1. Shut off the UPS and disconnect the input power cord from the wall outlet.
2. Open battery door.
3. Disconnect used battery. Connect new battery. (It is important that connectors be
firmly attached to new batteries.)
4. Close battery door
5. Properly recycle used battery.
1023922
Revision A
Green Lighting
Yellow Lighting
Yellow Flashing
Red Lighting
Red Flashing
Sounding every 5 seconds
Sounding (two beeps) every 5 seconds
Sounding every 0.5 seconds
Sounding (three beeps) every 30 seconds
Continuous sounding
Sounding (three beeps) every 5 seconds
User's manual
350 - 1500 VA
9