Indicators - Eaton Powerware 5110 User Manual

Indicators

1. On/Off Push Button/Test Switch
One switch controls the power to your equipment and performs a self-test to detect
overload or undercharged conditions.
Turn on the UPS
Press and hold the switch for more than one second and release the switch after the
beep. The UPS will start.
Turn off the UPS
Press and hold the switch for more than one second and release the switch. The
UPS will shut down completely.
Perform Self-Test
The UPS will perform self-test for about 4.5 seconds when the UPS is turned on and
the utility power is present.
2. Normal Mode (Green) LED
Indicates the UPS is providing mains power to your
equipment. When the LED is blinking the UPS is
providing power from the battery.
3. Fault (Red) LED
When blinking, LED could indicate an overload
condition or that the battery should be replaced. When
the LED is always on it indicates a short or UPS fault.
For details please see Indicator Table.
4. Battery Mode (Yellow) LED
Indicates the UPS is providing battery power to your
equipment.
UserÊs Manual 350-1500VA
1
4
2
3
7