Led Indicators - Eaton Tripp Lite Series Advanced User's Manual

LED Indicators

Battery Mode
NOTE
• To disable the alarm tone in Battery Mode, press and hold the power button for five seconds. The green
LED will flash and the UPS alarm tone will sound, indicating that the alarm has been disabled.
• To enable the alarm tone in Battery Mode, press and hold the power button for five seconds. The green
LED will flash and the UPS alarm tone will sound, indicating that the alarm has been enabled.
NOTE
3 3 . . 6 6 L L E E D D I I n n d d i i c c a a t t o o r r s s
The Tripp Lite Series UPS system rear panel indicates the UPS status via the UPS LED indicators.
shows the LED status and operational mode of the UPS.
Table 2. LED Status
Green (Flashing) Red (On)
10 Tripp Lite Series UPS Systems User Guide 93470A—Rev A
The default setting for the Battery Mode alarm tone is disabled. The Line Mode default
must be set to enabled before changing the On Battery alarm settings. The On Battery
audible alarm tones can be enabled or disabled in Battery Mode only. The alarm changes
in Battery Mode do not affect the Line Mode setting.
To verify the alarm status, test the UPS on battery power.
LED Status
Green (On)
Green (Flashing)
Green (Off)
Red (On)
Alarm
Off
Off
Sounding every second
Off
Continuously sounding
Table 2
UPS Status
Operating in normal line mode
Operating in battery mode
Low battery
UPS is off
UPS fault (See Table 3)