Information Button - DELTA DORE TYBOX PAC User Manual

Programming
6. To program the other mode (HEAT/COOL)
Turn the knob to .
Change the mode by pressing once on + or -
Press OK to confirm.
Turn the knob to PROG, then repeat steps 2 to 5.
7. Exiting the programming mode
Turn the knob to another mode.
COMMENTS: Depending on the configuration made
during installation, programming can be weekly or daily.
Likewise, this programming may be done in increments
of one hour, 30 minutes, or 15 minutes. To change these
settings, refer to the "installation guide", or contact our
customer service department or your installer.
- 16 -

Information button

In AUTO mode, pressing i once lets you know the
current mode (if the heat pump is reversible).
Pressing i a second time gives you the temperature of
the room or the set-point temperature according to the
installation configuration.
If your thermostat displays the temperature of the room
Current mode display
HEAT / COOL
Set-point temperature display
Return to normal display
(automatic after 30 seconds)
- 17 -