Programming
6. To program the other mode (HEAT/COOL)
Turn the knob to
.
Change the mode by pressing once on + or -
Press OK to confirm.
Turn the knob to PROG, then repeat steps 2 to 5.
7. Exiting the programming mode
Turn the knob to another mode.
COMMENTS: Depending on the configuration made
during installation, programming can be weekly or daily.
Likewise, this programming may be done in increments
of one hour, 30 minutes, or 15 minutes. To change these
settings, refer to the "installation guide", or contact our
customer service department or your installer.
Information button
The display of all information related to home automa-
tion features (outside temperature, consumption indica-
tion, etc.) requires an "activation" phase from the
RADIO TYBOX (see the home automation features
section).
- 16 -
AUTO
During the
,
or
repeatedly to find out:
• the room temperature or the set-point temperatu-
re (depending on the configuration during the
installation)
If your thermostat displays the temperature of the room
Normal display
Set-point temperature
display
i
, modes, press the
button
Mode display
- 17 -