Link All Devices To Wireless Network - Mitsubishi Electric MIFH1 Installation Manual

3

Link all devices to wireless network

POWER LED
Solid Green: Powered and communication
is established.
Slow Flashing Green (1 flash/
second): Receiver is powered.
Wait approximately 30 seconds for
communication to be established
between the wireless receiver and the
indoor unit. Check cable connection if
flashing does not stop after 30 seconds.
Fast Flashing Green (5 flashes/second):
Error in communication between
wireless receiver and the indoor unit.
Check cable connection.
Link remote controller to wireless network
Zone name
Wireless Setup
Wireless Setup
Back
Connected
Wireless Setup
Done
Press s or t to change the name or location of this zone,
then press NEXT.
Example: 67 = Meeting Room
Next
M28925
Press CONNECT to establish a link to the wireless network.
Connect
M32308
After a brief pause, the confirmation screen at left should
be displayed to verify that the wireless connection has been
established.
Press DONE to display the home screen.
M32307
1 Remove cover from wireless receiver.
2 Verify POWER light is solid green.
3 Press and release the CONNECT button.
4 If CONNECT light does not flash, another
receiver or RedLINK wireless adapter may be in
wireless setup mode. Exit wireless setup at the
other device.
CONNECT LED
Flashing Green: In wireless setup
mode.
Solid Green: RedLINK communication
is established.
Yellow: Please wait.
Red: RedLINK device is not
communicating.
Flashing status light times out
after 15 minutes of inactivity. Press
CONNECT again if necessary.
See complete zone list on page 8.
If E0 or E1 appears, see error codes on page 10.
3 69-2426—01