Download  Print this page

Mitsubishi Electric MIFH1 Installation Manual page 4

Controller kit
Hide thumbs

Advertisement

Wireless System Installation Guide
Link Portable Central Controller to RedLINK™ network (optional)
WIRELESS SETUP
Press to link
another receiver
YES
CONNECT MORE?
Link outdoor sensor to RedLINK™ network (optional)
Press and release
69-2426—01
CONNECT
M28481
Press to save
and exit
NO
M28482
M28483
1 Make sure the CONNECT light on the
wireless receiver is flashing.
2 Press CONNECT at the Portable Central
Controller. There will be a short delay as the
Portable Central Controller seeks a signal
from the wireless network.
3 When the screen displays "Connected,"
press DONE.
4 Press NO at the next screen to save and exit.
(Or press YES and repeat steps 1-4 to link
another receiver.)
If E1 appears, see error codes on page 10.
The linking procedure may time out if there is
no keypress within 15 minutes. To begin again,
press and hold the blank space (or arrow, if
present) in the lower right corner of the screen
until the display changes (about 3 seconds).
1 Make sure the CONNECT light on the
wireless receiver is flashing.
2 Press and release the CONNECT button on the
back of the sensor.
3 Check remote controller to verify that the
outdoor sensor is working. After about
15 seconds, the remote controller should
display outdoor temperature and humidity.
4

Hide quick links:

Advertisement

loading

  Related Manuals for Mitsubishi Electric MIFH1

This manual is also suitable for:

Mcch1Mrch1Mos1