Exit wireless setup
Press and release the CONNECT button at the wireless receiver to exit wireless setup (light
should stop flashing and remain solid). Replace cover on wireless receiver.
Note: The wireless receiver will automatically exit wireless setup after 15 minutes
Note: If installing more than one receiver, you must exit wireless setup before
installing remote controller and additional receiver.
Customize remote controller (installer setup)
Follow the steps below to begin installer setup. At each function screen, press s or t to
change the setting as desired, then press NEXT to advance to the next function screen.
See tables on pages 6-8 for a description of options for each function.
To begin, press and hold the FAN and
buttons until the display changes. "WAIT"
will be displayed for up to 40 seconds.
Press DONE to save & exit.
Press s or t to change
setting (see tables on pages
Press NEXT to display next