Table of Contents
Advertisement
4.3.2 AP Discovery
Use this function to detect and manage all the supported APs in the network segments.
AP Discovery Settings
When the administrator tries to discover a new AP, select Factory Default or Manual in Admin Settings Used
to Discover field; enter the current IP range of the APs if they are not in default value. Then click Scan Now
button. If the new AP has been discovered, it will appear in the following Discovery Results list. If there is a
warning message showing below the Discovery Settings, follow the instructions to change configurations.
Please fill in the required data.
Note: The APs (and the firmware version as well as the hardware number) that are supported include:
1. DWL-2100 (FW v2.20/2.30eu and v2.20/2.30na;HW A4),
2. DWL-3200-v2.3+ (FW v2.30; HW B1)
3. DWL-8200 (FW v1.20; HW A2)
To discover AP manually, please select/fill in the required data.
AP Type: List the current AP types to choose from.
Interface: Select between LAN ports where the APs are connected.
Admin Settings Used to Discover: Select Manual, enter the current IP range of the APs in IP
Address field if they are not in default value. The IP of AP with factory default setting is "192.168.0.50".
If the AP was discovered before, the IP address of the AP should have been changed. Please enter the
right IP address of the AP or reset the AP to default values. Login ID is the admin ID of the AP. Password
Chapter 4. Web Interface Configuration
57
Advertisement
Table of Contents
