D-Link DSA-6100 User Manual page 40

VLAN:
Enable: When enabled, this VLAN segment will be active.
Enable User Authentication: When enabled, users on this VLAN interface are required to log in before
accessing the network.
VLAN Tag: Enter any integer number within the range of 2 ~ 4094 (1 is reserved for system) as the Tag ID
for this VLAN segment.
Mode:
NAT: All IP addresses of hosts on the VLAN interface will be converted into the IP address of the
o
WAN1 interface and onward to outside the network.
ROUTER: All IP addresses of hosts on the VLAN interface will remain the same while the IP packets
o
travel through WAN1 interface, thus making the DSA-6100 act like a router.
IP address: IP address of each network interface.
Subnet Mask: Subnet Mask of the LAN/VLAN interface.
VLAN DHCP Configuration: DHCP options for this VLAN interface include Disable, Enable, and Relay.
DSA-6100 User Guide
34