D-Link DSA-6100 User Manual page 64

is the admin password of the AP. If the AP is in default value, just select Factory Default, system can
discovery the APs.
IP Addresses of APs after Discovery: The start IP to be assigned will be entered here.
Scan Now: Click the Scan Now button and the APs that match the given settings will be shown in the
Discovered Results below. If any IP address among the IP range assigned for a specific AP is used,
there will be a warning message showing up. Please change the IP Addresses of APs after Discovery
and then click Scan Now again. For the desired AP, input the desired AP name and admin password,
select one template to apply, select the check box, and click Add to add the discovered AP to the List.
For more information about the template, please refer to 4.3.4 Templates.
Background AP Discovery
The system supports discovering APs periodically in background. The New IP Address Assignment and
Access to the AP Admin Interface configuration in Background Auto Discovery page are the same as in the
Discovery Settings. Click Configure and then select Enable to set the configuration. When Auto Adding AP to
the list is enabled, the system will add the discovered APs into the List table automatically and apply the
selected template in the Template Applied option to the AP. When the configurations are set as requirement,
the system will discover new APs periodically and automatically in background.
Click Configure to enter the Background AP Discovery page to have further configuration.
The Interface, Admin Settings Used to Discover and IP Addresses of APs after Discovery configurations
are the same as the settings mentioned above. Check Enable in the Status field to have more configuration.
Select Interval setting from the drop-down menu to set the system to scan periodically according to this setting
(the default value is 10 minutes). If Auto Adding AP to the list is enabled, a new detected AP will be assigned
an available IP address from the IP address range set in IP Addresses of APs after Discovery and applied
with the selected template automatically.
DSA-6100 User Guide
58