D-Link DSA-6100 User Manual page 34

IP Address: The IP address of the WAN1 port.
Subnet Mask: The subnet mask of the WAN1 port.
Default Gateway: The gateway of the WAN1 port.
Preferred DNS Server: The primary DNS Server of the WAN1 port.
Alternate DNS Server: The substitute DNS Server of the WAN1 port. This is not required.
Enable Bridge Mode: Bridge all WAN and LAN interfaces. These interfaces will be in the same
network segment. When the WAN1 is set to use a static IP address and "Enable Bridge Mode" is
checked, the DSA-6100 will act as a switch and WAN2, LAN1 and LAN2 ports will share the same
static IP address from WAN1. The pictures below are the results on the WAN2 and LAN2 when
Bridge Mode is enabled on the WAN1 interface.
Dynamic IP address: Configure WAN port settings automatically using external DHCP Server. It is only
applicable for the network environment where the DHCP Server is available in the network. Click the Renew
button to get an IP address.
DSA-6100 User Guide
28