Table of Contents
Advertisement
4. LCD: Shows the information about the System and Network listed below:
System Info:
H.W. Status (CPU Temperature)
Utilization (CPU (%) and Memory (%))
System Time
Boot-up Time
Firmware
Network Info: WAN 1 / WAN 2 / LAN 1 / LAN 2
Setting (IP Address and Netmask)
Loading (In/Out Pkts/s and In/Out Bytes/s)
Status (Connected or Disconnected)
5. USB Port: Reserved for future use.
6. Console Port: The system can be configured via HyperTerminal. For example, if you need to set the
Administrator's Password, you can connect a PC to this port as a Console Serial Port via a terminal
connection program (the terminal's configuration must be 9600bps, 8, N, 1, flow control - none) to change
the Administrator's Password.
7. LAN1 / LAN2 Ports: The two LAN ports can be independently configured and set to disallow users to
access Internet before authentication. Administrators can therefore choose to force authentication on
users connected to these ports.
8. WAN1 / WAN2 Ports: The two WAN ports are connected to a network which is not managed by the
DSA-6100, and this port can be used to connect to the ATU-Router of an ADSL, or the port of a Cable
Modem, or the Switch or Hub on the LAN of an organization.
DSA-6100 User Guide
8
Advertisement
Table of Contents
