Filter Change; Changing The Filter Cartridges; Month System Maintenance - Watts Premier FILTER-PURE Installation, Operation And Maintenance Manual

Changing The Filter Cartridges

Your system is equipped with valved heads which will automatically turn off the
water supply to each filter when the filter is released, thus you do not need to turn
off the incoming water supply at the Adapt-a-Valve. The faucet must be off when
filters are replaced. To make the removal of the filter cartridges easier, the heads
& cartridges may be swiveled up to 90 degrees as shown in the pictures below.

6 Month System Maintenance

√ One sediment filter
Replace:
√ One carbon Block
Step 1
Place a towel under the RO module to catch any excess water that
may drip out from the filters during the changeover.
To remove a filter cartridge:
Step 2
valved head above the filter. Pull cartridge downward (from the
head) to remove. Release button and discard old filter.
To install a filter cartridge:
Step 3
the cartridge into the valved head until you hear an audible "click"
(the button does not need to be pressed to install new filters).
Optional Filters:
√ UF Membrane Filter
√ Lead+Chemical Reducing CB
(Red Label P/N: 105311)
(Yellow Label P/N: 105351)
Push & hold the button on the
Remove the seal cap and insert
(P/N: 105321)
(P/N: 105371)
9