Table 2-1 Control - Hvac Field Descriptions - Proliphix IMT550c Configuration Manual

Beta Draft Confidential
Use

Table 2-1 Control - HVAC Field Descriptions

Field
Temperature
Zone Temperature
Local Temperature
Zone Humidity
Heat Setting
Cool Setting
Internet Managed Thermostat Configuration Guide, Release 1.0
Part No. 600-03001-550, Rev. 1
Table 2-1 to configure the Control - HVAC fields.
Description
Displays the current temperature of the zone if temperature averaging is
disabled.
Average temperature of any combination of Local, Remote Sensor #1 (RS
#1), Remote Sensor #2 (RS #2), or Remote Sensor #3 (RS# 3) if
temperature averaging is enabled. (See
In a range of -30
Also displays the current status of the Zone Temperature alarm. If an alarm
occurs, you must repair the condition which caused the alarm before
resetting the alarm. (See
This field is blank if no Zone Temperature alarm exists.
thermostat has dropped below the pre-set temperature threshold.
thermostat has risen above the pre-set temperature threshold.
Displays the current temperature of the local sensor. This field is disabled if
the local thermostat sensor is not included in temperature averaging.
In a range of 40
Displays the current Zone Humidity.
In a range of 0% to 95%
thermostat has dropped below the pre-set humidity threshold.
thermostat has risen above the pre-set humidity threshold.
Displays the current temperature programmed for the heating system. This
field is disabled if the HVAC mode is set to Cool or Off. (See
(page 2-5).) This field is not visible if the thermostat is configured to be a
cool-only controlling device. (See
To modify this field, use the drop-down menu to select a Heat Setting.
°
40 F(4.5
Displays the current temperature programmed for the cooling (A/C) system.
This field is disabled if the HVAC mode is set to Heat or Off. (See
Mode (page
be a heat-only controlling device. (See
To modify this field, use the drop-down menu to select a Cool Setting.
°
40 F(4.5
° ° °
F(-34 C) to 199 F(95
Alarms Page (page
Low Temperature Alert! – The temperature monitored within the
High Temperature Alert! – The temperature monitored within the
° ° °
F(4.5 C) to 110 F(43.5
Low Humidity Alert! – The humidity level monitored within the
High Humidity Alert! – The humidity level monitored within the
Advanced Page (page
° ° °
C) to 110 F(43.5 C)
2-5).) This field is not visible if the thermostat is configured to
° ° °
C) to 110 F(43.5 C)
Control Page
Advanced Page (page 2-27).)
°
C)
2-20).)
°
C)
HVAC Mode
2-27).)
HVAC
Advanced Page (page 2-27).)
2-3