Table of Contents
Advertisement
1.7> SENSOR SETUP
To enter the SENSOR SETUP menu, press the SELECT button, a sub menu display
as follows,
>
POST-ALARM RECORD TIME
ALARM DURATION
CHANNEL-1
CHANNEL-2
CHANNEL-3
CHANNEL-4
1.7.1> POST-ALARM RECORD TIME
When sensors or motion detection are activated, they will trigger the recorder
to record. As the activated sensors stop, the recording activity will remain a
period of time, which can be adjusted by pressing the SELECT button. The
options may be 5 sec¡ B 10 sec ¡ B 15 sec ¡ B 20 sec ¡ B 25 sec and 30 sec.
1.7.2> ALARM DURATION
When any sensor connected to the recorder or motion detection is activated,
the recorder will react an alarm to start the buzzer and relay. The buzzing
time may be OFF¡ B 5 sec¡ B 10 sec¡ B 15 sec¡ B 20 sec¡ B 25 sec¡ B 30 sec and CONT
(continuous buzzing).
*Note: If under CONT (continuous) mode, press any button on the front panel
to clear buzzer and relay out.
1.7.3> SENSOR TYPE SETTINGS
The NORMAL OPEN, NORMAL CLOSE or NOT INSTALLED can be set up
for each channel.
SENSOR SETUP
TYPE: NORMAL-OPEN
TYPE: NORMAL-CLOSE
NOT INSTALLED
TYPE: NORMAL-OPEN
9
30
20
Version 1.2
Advertisement
Table of Contents
