Ami Bios Setup; System Test And Initialization - EverFocus eIVP5600 User Manual

4. AMI BIOS Setup

4.1 System Test and Initialization

The board uses certain routines to perform testing and initialization. If an error, fatal or non-fatal,
is encountered, a few short beeps or an error message will be outputted. The board can usually
continue the boot up sequence with non-fatal errors.
The system configuration verification routines check the current system configuration against the
values stored in the CMOS memory. If they do not match, an error message will be outputted, in
which case you will need to run the BIOS setup program to set the configuration information in
memory.
There are three situations in which you will need to change the CMOS settings:
You are starting your system for the first time
•
You have changed your system's hardware
•
The CMOS memory has lost power and the configuration information is erased
•
The system's CMOS memory uses a backup battery for data retention, which is to be replaced
once emptied.
20
eIVP5600 AI Mobile NVR
Chapter
4