New Procedure For Adjusting Alarm Thresholds - Cisco Prisma II Installation And Operation Manual

New Procedure for Adjusting Alarm Thresholds

Adjusting Alarm Thresholds
Relative alarm thresholds are both displayed and stored as a relative value. The new
method for adjusting alarm thresholds allows the operator to choose any valid
increment size and adjust the alarm threshold to any valid value.
Follow these steps to change an adjustable alarm threshold from the factory default.
1.
At the MODULE menu, press the
Result: The STATUS menu appears on the ICIM.
2.
Press the
n/a appears, you cannot configure that alarm threshold. Press the
highlight the next parameter's alarm threshold.
3.
When the threshold that you wish to set is highlighted, press the
4.
Press the
5.
Press the
Note: Press the Cancel (
6.
Press the
Result: Data Saved appears.
7.
When finished, press the
78-739260-01 Rev F
key. The alarm thresholds previously set appear. If the label
SEL
key or the key to change the increment size.


key or the

ALRM
)key to return to the previous menu.
key to save the changes.
ENTER
MAIN
key to return to the MAIN menu.
Operation Using the ICIM
key.
STAT
key to adjust the alarm threshold.
key to

key.
ENTER
3-41