The Back Panel - Cisco Prisma II Installation And Operation Manual

The Back Panel

Back Panel Connectors
Blind-mate connectors make it easy to install this module. The push-on connector on
the back of the module mates with the backplane connector inside the chassis. The
110-pin connector provides the following:
Electrical power input connection
•
Alarm communications
•
Status-monitoring connections
•
Communications and control connections
•
Power and Communications Connector
The power and communications connector on the back of the module mates with a
connector inside of the chassis, and supplies power from the chassis to the optical
amplifier. The 110-pin connector also routes alarm and status-monitoring
information from the optical amplifier to the Prisma II Chassis.
1-6 Introduction 78-739260-01 Rev F