Cisco Prisma II Installation And Operation Manual page 70

SNMP Configuration Capability,
7.
Press the
Result: The Adjust menu for the selected IP parameter appears and the first
segment of the address is highlighted.
Note: The example above shows the IP Address parameter Adjust menu. The
Adjust menus for IP Subnet and Gateway IP are similar.
8. Enter the correct numbers for the first segment of the address.
Notes: One of two methods can be used to enter the numbers, as follows:
• Press the
• Press the
appears on the front panel LCD.) Then enter the exact number using the
number keys on the 12-key numeric keypad.
9.
Press the
segment to the right. (You can also use the
address segment of your choice.)
Note: If you are using the numeric entry mode, the cursor moves to the next
address segment to the right automatically after you enter the last digit of the
current address segment.
10. Repeat steps 8 and 9 until all address segments are entered.
Result: After you enter the last address segment and press the Enter key, the
system returns to the IP Setup menu.
3-30
Continued
key.
SEL
- - - - - - - - - -
S h e l f
S l o t
- - - - - - - - - -
A d j u s t
I P A d d r e s s
1 7 2 . 1 8 . 9
. 2 2 7
or keys to increase/decrease the number to set value.

key to change to the numeric entry mode. ("Numlock On"
SHIFT
key to accept your entry and move to the next address
ENTR
Operation Using the ICIM
I C I M
7
1 5
or
 
keys to move to the
78-739260-01 Rev F