Cisco Prisma II Installation And Operation Manual page 15

Laser Safety,
Continued
Safe Operation For Software Controlling Optical Transmission Equipment
If this manual discusses software, the software described is used to monitor and/or control
Cisco and other vendors' electrical and optical equipment designed to transmit video, voice,
or data signals. Certain safety precautions should be observed when operating equipment of
this nature.
For equipment specific safety requirements, refer to the appropriate section of the equipment
documentation.
For safe operation of this software, refer to the following warnings.
WARNINGS:
• Ensure that all optical connections are complete or terminated before using this
equipment to remotely control a laser device. An optical or laser device can pose a
hazard to remotely located personnel when operated without their knowledge.
• Allow only personnel trained in laser safety to operate this software. Otherwise,
injuries to personnel may occur.
• Restrict access of this software to authorized personnel only.
• Install this software in equipment that is located in a restricted access area.
78-739260-01 Rev F xv