How To Identify Which Power Supply Model Is In Your Server; Replacing A Pcie Card (Mass Storage Controllers) - Cisco UCS C200 Installation And Service Manual

Installing or Replacing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

How to Identify Which Power Supply Model is in Your Server

There are two methods that you can use to identify which power supply is installed in your server:
1.
2.

Replacing a PCIe Card (Mass Storage Controllers)

The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and navigate to the page for your server
model and generation:
http://www.cisco.com/en/US/prod/ps10265/ps10493/c-series_part_numbers.html
In addition to the hardware replacement procedure, this section contains the following topics:
•
•
•
Note For network adapter PCIe cards, see the
page
If you do not know which cards are installed in your server, see the
Note
Installed in Your Server" section on page
LSI MegaRAID SAS controller cards are enabled with beep codes that can indicate activity within the
Note
RAID array. See the
Installing a PCIe card requires that you first remove the riser card assembly from the chassis. To install
or replace a PCIe card, follow these steps:
Step 1 Remove a PCIe card:
a.
b.
Cisco UCS C200 Server Installation and Service Guide
3-28
Visually inspect th e power supply at the rear of the server. The new power supply model
R2X0-PSU2-650W-SB has a sticker with the number 650W-SB; the old power supply has no sticker.
Use the Cisco Integrated Management Controller (CIMC) GUI to view the power supply model:
Use a browser to connect to CIMC using the CIMC IP address.
a.
Log in to CIMC using your administrator user name and password.
b.
On the CIMC Server tab, click Inventory.
c.
On the Inventory pane, click the Power Supplies tab.
d.
e. View the power supply model number in the Product ID column. The new power supply is
listed by the manufacturer's model number, R2X0-PSU2-650W-SB.
Special Installation Instructions For the LSI MegaRAID Battery Backup Unit, page 3-30
Identifying Which Cards Are Installed in Your Server, page 3-32
LSI MegaRAID Card Beep Codes, page 3-32
3-25.
"LSI MegaRAID Card Beep Codes" section on page 3-32
Power off the server as described in the
page 3-6.
Disconnect all power cords from the power supplies.
"Replacing a PCIe Card (Network Adapters)" section on
3-32.
"Shutting Down and Powering Off the Server" section on
Chapter 3 Maintaining the Server
"Identifying Which Cards Are
for more information.
OL-20732-02