Replacing A Pcie Card (Network Adapters) - Cisco UCS C200 Installation And Service Manual

Chapter 3 Maintaining the Server
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-14
1

Replacing a PCIe Card (Network Adapters)

Note For mass storage controller PCIe cards, see the
section on page
If you are installing a Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01), there are prerequisite
Note
considerations. See
(N2XX-ACPCI01), page
If you are using the server in UCSM mode, only certain combinations of network adapter cards are
Note
qualified for support. See
The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and navigate to the page for your server
model and generation:
http://www.cisco.com/en/US/prod/ps10265/ps10493/c-series_part_numbers.html
Installing a PCIe card requires that you first remove the riser card assembly from the chassis. To install
or replace a PCIe card, follow these steps:
Remove a PCIe card:
Step 1
a.
OL-20732-02
Removing and Replacing a PCIe Riser Card Assembly
Riser card assembly (top view)
3-28.
Special Considerations for the Cisco UCS P81E Virtual Interface Card
3-27.
Supported Network Adapter Card Combinations for UCSM Mode, page
Power off the server as described in the
page 3-6.
1
1
2 Riser card
"Replacing a PCIe Card (Mass Storage Controllers)"
"Shutting Down and Powering Off the Server" section on
Cisco UCS C200 Server Installation and Service Guide
Installing or Replacing Components
2
D-10.
3-25