Installing A Trusted Platform Module - Cisco UCS C200 Installation And Service Manual

Installing or Replacing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-12
1
1

Installing a Trusted Platform Module

The qualified and supported part numbers for this component are subject to change over time. For the most
up-to-date list of replaceable components, see the following URL and navigate to the page for your server
model and generation:
http://www.cisco.com/en/US/prod/ps10265/ps10493/c-series_part_numbers.html
To install or replace a trusted platform module (TPM), follow these steps:
Remove a TPM:
Step 1
a.
b.
c.
Caution
d.
e.
f.
g.
Install a TPM:
Step 2
a.
b.
c.
Cisco UCS C200 Server Installation and Service Guide
3-22
Removing and Replacing a Motherboard CMOS Battery
2
+
Motherboard CMOS battery socket
(positive side toward chassis wall)
Power off the server as described in the
page 3-6.
Disconnect all power cords from the power supplies.
Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the rack.
Remove the top cover as described in the
on page 3-8.
Remove the PCIe riser card assembly to provide clearance to the TPM.
See the "Replacing a PCIe Riser Card Assembly" section on page 3-24
Remove the securing screw that holds the TPM to the motherboard standoff (see
Lift up on both ends of the TPM to free it from the socket on the motherboard.
Align the connector that is on the underside of the new TPM with motherboard socket JP2, and then
press firmly on both ends of the TPM to press the connector into the socket.
Replace the securing screw that holds the TPM to the motherboard standoff.
Replace the PCIe riser card assembly.
2
Battery retaining clip
"Shutting Down and Powering Off the Server" section on
"Removing and Replacing the Server Top Cover" section
Chapter 3 Maintaining the Server
for instructions.
Figure 3-13).
OL-20732-02