Identifying Which Cards Are Installed In Your Server; Lsi Megaraid Card Beep Codes - Cisco UCS C200 Installation And Service Manual

Installing or Replacing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
h.

Identifying Which Cards Are Installed in Your Server

If you do not know which model of mass storage controller card is installed in your server, you can see
the model names displayed on your console screen during bootup. However, you can only see this
information if Quiet Boot is disabled in the server BIOS. Quiet Boot must also be disabled in order to
see prompts for LSI option ROM-based utilities.
To disable Quiet Boot so that the device names and prompts for the option ROM-based LSI utilities
display during bootup, follow these steps:
Boot the server and watch for the F2 prompt during bootup.
Step 1
Press F2 when prompted to enter the BIOS Setup utility.
Step 2
On the Main page of the BIOS Setup utility, set Quiet Boot to Disabled. This allows non-default prompts
Step 3
and POST messages to display during bootup instead of the Cisco logo screen.
Press F10 to save your changes and exit the utility.
Step 4

LSI MegaRAID Card Beep Codes

Table 3-3
and changes from the optimal state of your RAID array. For full documentation on the LSI MegaRAID
cards and the LSI utilities, refer to the LSI documentation for your card.
Table 3-3 Summary of LSI MegaRAID Card Beep Codes
Beep Code
3 seconds on, 1 second off
1 second on, 1 second off
1 second on, 3 seconds off
Cisco UCS C200 Server Installation and Service Guide
3-32
Replace the LSI MegaRAID card to the PCIe riser. See the
Adapters)" section on page 3-25
contains a summary of the LSI MegaRAID card beep codes. These beep codes indicate activity
LSI Firmware State
SPEAKER_OFFLINE_ENTRY
SPEAKER_DEGRADED_ENTRY
SPEAKER_HOTSPARE_ENTRY
for instructions.
Cause (Depending on RAID Level)
RAID 0: One or more drives offline.
•
RAID 1: Two drives offline.
•
RAID 5: Two or more drives offline.
•
RAID 6: More than two drives offline.
•
RAID 1: A mirrored drive failed.
•
RAID 5: One drive failed.
•
RAID 6: One or two drives failed.
•
A hot spare drive has completed the rebuild process
and has been brought into the array.
Chapter 3 Maintaining the Server
"Replacing a PCIe Card (Network
OL-20732-02