Cisco UCS C200 Installation And Service Manual page 60

Installing or Replacing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Install a DIMM:
Step 2
With the ejector levers at both ends of the DIMM slot fully open, orient the DIMM's alignment notch
a.
with the alignment key in the DIMM slot.
Press down on both top corners of the DIMM simultaneously until the ejector levers click and lock
b.
in place on the DIMM.
c. Replace the air baffle and the top cover.
d. Replace the server in the rack, replace power cords and any other cables, and then power on the
server by pressing the Power button.
Figure 3-10
1 DIMM slots (twelve)
3
Alignment key in DIMM slot
Cisco UCS C200 Server Installation and Service Guide
3-18
Removing and Replacing Memory Modules
1
Chapter 3
3
2
2 DIMM slot ejector lever (two on each slot)
Maintaining the Server
OL-20732-02