Reset To Factory Configuration - KVH Industries TracPhone V7-IP User Manual

Reset to Factory Configuration

If the system's network becomes corrupted such that you can no
longer access the TracPhone V7-IP web interface, and KVH Technical
Support is unable to access the system remotely, you can reset the
system to its original factory settings.
Important!
Perform a factory reset only if directed by KVH Technical Support.
This function should only be used as a last resort when all other
options fail.
The following settings are included in the reset:
• Reverts to Standard (DHCP) physical Ethernet port configuration
• Deletes any custom CommBox configurations
• Clears any configured no-transmit zones
• Sets the ICM's LCD brightness to High
To reset the system to its factory settings, follow these steps:
1. At the ICM's front panel, press MENUS until the display
shows "DIAGNOSTIC TOOLS."
2. Press ACCEPT.
3. At "KVH SUPPORT IP," press NEXT.
4. At "CALIBRATE GYROS," press NEXT.
5. At "FACTORY RESET," press ACCEPT.
6. At "PROCEED WITH RESET?," press ACCEPT.
The system reverts to its original factory settings. Do not power off the
system while this reset is in progress.
TracPhone V7-IP User's Guide
Network Configuration
79