KVH Industries TracPhone V7HTS Replacement Instructions
For remote service module
Hide thumbs
Also See for TracPhone V7HTS:
- Conversion instructions (11 pages) ,
- Quick start manual (2 pages) ,
- Installation manual (61 pages)
Advertisement
Quick Links
TracPhone V7
Replacement Instructions
Technical Support
If you need technical assistance, please contact KVH Technical Support:
Europe, Middle East, Africa, Asia-Pacific:
Phone: +45 45 160 180
Email: mvbsupport@kvh.com
The following instructions explain how to replace
the remote service module (GPRS modem) in a
®
TracPhone
V7-HTS or V7-IP antenna.
NOTE: Your antenna might have parts that differ from
those pictured in this document. Such differences have no
bearing on the instructions unless noted otherwise.
Tools Required
This procedure requires the following tools:
• #2 Phillips screwdriver
• Flat-head jeweler's screwdriver
• Flat-head torque screwdriver set to 5 in.-lbs
• Flush cutters
• Adhesive remover
KVH, TracPhone, and the unique light-colored dome with dark contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2013-2017 KVH Industries, Inc., All rights reserved. 54-0882 Rev. C | 72-0572
/V7
Remote Service Module
HTS
IP
North/South America, Australasia:
Phone: 1 866 701-7103 (U.S. only) or +1 401 851-3806
Email: mvbsupport@kvh.com
Figure 1: Remote Service Module
1
Advertisement
Related Manuals for KVH Industries TracPhone V7HTS
Summary of Contents for KVH Industries TracPhone V7HTS
- Page 1 All other trademarks are property of their respective companies. The information in this document is subject to change without notice. No company shall be liable for errors contained herein. © 2013-2017 KVH Industries, Inc., All rights reserved. 54-0882 Rev. C | 72-0572...
- Page 2 Step 1 - Remove the Radome Figure 2: Remove the Radome Follow the steps below to disconnect power and remove the radome. a. Power off and unplug the ICM or CommBox- ACU and modem to disconnect power from the antenna. Follow all shipboard lockout-tagout procedures, where applicable.
- Page 3 Step 2 - Replace the Remote Service Figure 3: GPRS DB9 Connector, Cable, and Tie-Wraps Module Follow the steps below to replace the remote service module. a. Disconnect the GPRS cable from the remote service module (see Figure 3). To avoid breaking the DB9 connector’s retaining screws, loosen the retaining screws with a jeweler’s screwdriver.