Physical Ethernet Port Configurations - KVH Industries TracPhone V7-IP User Manual

TracPhone V7-IP User's Guide
Network Configuration

Physical Ethernet Port Configurations

74
By default, all four "User Ethernet" ports on the rear panel of the ICM
are set up for a standard LAN configuration – the ICM assigns IP
addresses to all devices connected to its network. However, at the
TracPhone V7-IP web interface, you can modify the ICM to support
any of the following alternate configurations:
• "Static IP Port Configuration" on page 75
• "Dual Dome Port Configuration" on page 76
• "Legacy Port Configuration" on page 77
Important!
If you select the Static IP, Dual Dome-Secondary, or Legacy
configuration, you will not be able to use minivsat.kvh to access the
web interface. You will need to enter the IP address of the ICM (default
is 192.168.0.9 in Static IP and Legacy modes, 192.168.0.10 in Dual Dome
-Secondary mode). In addition, if you select the Dual Dome-Secondary
or Legacy configuration, you will not be able to change any other
settings on the Network Settings page.
To select a physical Ethernet port configuration, follow these steps:
1. At the TracPhone V7-IP web interface, click the Settings tab.
Then click Network Settings.
2. In Physical Ethernet Port Configuration, click Edit.
3. If the Login window appears, log in with the Administrator
password.