Wired DHCP Configuration
In a wired DHCP configuration, vessel computers connect to the ICM
via Ethernet cables and receive IP addresses from the ICM. This is the
system's default configuration.
Figure 6-1 Wired DHCP Configuration (Example)
ICM
192.168.5.100
Bridge PC
To configure a wired DHCP network connection, follow these steps:
1. Connect your computers and other network devices to any of
the four "User Ethernet" ports on the rear panel of the ICM.
NOTE: Use straight-through 100 Mbps fast Ethernet UTP CAT5 cables (or
better) with RJ45 connectors.
2. Make sure the computers are configured for DHCP addressing
(see
User Ethernet
1 2 3
LAN: 192.168.5.1
192.168.5.101
Officers PC
"Configuring Computers for DHCP" on page
TracPhone V7-IP User's Guide
Network Configuration
192.168.5.102
Crew PC
63).
59