KVH Industries TracPhone V7-IP User Manual page 97

Error Description
128 The software update failed. Retry updating the software. If
it fails again, check the power/data cable and the wires on
the back of the ICM.
200 The antenna is not receiving adequate DC power from the
ICM. Check the power/data cable and the wires on the
back of the ICM.
204 The antenna's main board has lost RF communications. Try
updating the software (see
page 124).
206 The antenna's azimuth motor or limit switch failed. Contact
KVH.
208 The antenna's elevation motor or limit switch failed.
Contact KVH.
216 The antenna's cross-azimuth motor or limit switch failed.
Contact KVH.
218 The antenna's skew motor or limit switch failed. Contact
KVH.
219 One of the antenna's gyros is out of calibration. Try
recalibrating the gyros (see
page 135). If a gyro fails to calibrate, contact KVH.
220 One of the antenna's gyros failed. Contact KVH.
221 The system is not receiving any data from the GPS. Contact
KVH.
222 The antenna's internal temperature exceeds acceptable
limits. Turn off the system and allow it to cool. If the
problem persists, contact KVH.
234 The antenna is not receiving satellite signal strength (RSSI)
data from the ICM. Try these steps:
• Turn the ICM off, then back on.
• Check the wires on the back of the ICM.
• Check the power/data cable.
235 The antenna has lost RF communications. Contact KVH.
240 The antenna's LNB is not receiving the proper power from
the ICM's receive (RX) RF cable. Check the RX RF cable.
TracPhone V7-IP User's Guide
"Software Updates" on
"Gyro Calibration" on
Troubleshooting
101