Installing The Sata Or Scsi Sixth Drive Accessory; Figure 37. Remove The Drive Blank From The Chassis - Intel SR2400 User Manual

Hardware Installations and Uprades

Installing the SATA or SCSI Sixth Drive Accessory

The SATA and SCSI sixth drive accessories is used when a sixth SATA hot-swap drive or a sixth
SCSI hot-swap drive is needed. The SATA or SCSI backplane accessory kit is required to install
this accessory. After installing the sixth drive accessory kit, see
swap Hard Disk Drive" for instructions on installing a hot-swap disk drive.
NOTE
You cannot use the sixth drive accessory kit to mix installations of SATA
and SCSI drives. In other words, if you have five SCSI drives installed, you
cannot use the sixth drive accessory as a way to install a SATA drive. Your
drive types must match the type of backplane that you have installed.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information."
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see
4. Remove the front bezel if it is installed. For instructions, see
5. Remove the drive blank from the sixth drive bay by using a long screwdriver to push it out
through the front of the chassis.

Figure 37. Remove the Drive Blank from the Chassis

"Removing a SATA or SCSI Hot-
"Removing the Chassis Cover."
"Removing the Front
"Safety
Bezel."
TP01366
67