Remote Control Mode; Reset To Factory Default Settings; Pc Interface Control - Extech Instruments DCP60 User Manual

Remote Control Mode
To control the output voltage and current by remote control connector (10) please refer to the
section entitled Remote Control.
Reset to Factory Default settings
1.
Switch OFF the power supply
2.
Push and hold both front panel voltage and current control knobs at the same time
3.
Switch ON the power supply again
4.
Release the front panel voltage and current control knobs
PC Interface Control
To control the power supply using the supplied Software, refer to the PC Interface Control
Section.
6 DCP60‐EU‐EN V1.4 9/13