Border Cleaning Mode; Fixed Point Cleaning Mode; Intensive Cleaning Mode; Go Back Charging Mode - ECOVACS Deebot D56 User Manual

Border Cleaning Mode

Fixed Point Cleaning Mode

Intensive Cleaning Mode

Go Back Charging Mode

Route description: under this mode, once the robot detects hard objects
(like wall), it will run along it to clean until it meets obstacle and change the
former route.
Under this mode, robot helps to clean the corner of wall, table,
sofa and bed where it is beyond the mode of automatic cleaning.
The operation of this mode takes around 25 minutes and then robot
goes back charging by itself.
Route description: under this mode, robot runs from inside in spiral way and
focused on the certain point to clean for one time. The cleaning coverage is a
round shape with diameter of 1.2 meter.
This mode is applicable to certain area with plenty of dust.
Under common circumstance, the cycle of one fixed point cleaning
takes around 6 minutes. During operation, if robot continually meets
obstacle or detects staircase, it would shift to avoid obstacle and
staircase, and then turn back to work under this mode.
Robot will stay where it stops and give tip music after finishing.
Route description: the route is the same as automatic mode. The robot will
go back charging before run off the battery.
Under the same ground circumstance, the cleaning effect is the best.
Please choose this mode when the ground is quite dirty.
Route description: robot will search for charging block automatically when it
detects low battery, green light flashing once the charger is connected.
E n j o y S m a r t e r L i f e !
13