Mounting - Sierra Wireless Airlink Raven XE HSPA User Manual

AirLink Raven XE HSPA User Guide
36

Mounting

An optional accessory for your Raven XE is a mounting kit, which includes a
bracket. The bracket is designed to snugly cradle the modem and hold it in place
where you need it. You can use a strap around the bracket and modem for extra
security. The bracket can be attached to a stationary location using #6 screws
with the mounting hole diameter approximately 0.15 inches.
Bracket installation instructions are as follows:
1. Mount the bracket using #6 screws. There are two holes on each side of the
bracket to fasten the screws, and at least one hole on each end is required for
mounting the bracket.
2. Position Raven XE between the alignment ears.
3. Engage the top groove in the body of the Raven XE with the two tabs.
4. Push in the center on the far side of the Raven XE so that it touches the side
of the bracket.
5. Press down, and release when the upper groove on the far side of the Raven
XE aligns with the tabs.
6. Installation into the mounting bracket is complete.
To remove the Raven XE, press on the two edges of the modem and the bracket.
By doing this, the modem will snap out of the mounting bracket.
Figure 4-6: Optional Mounting Bracket
20080616