AirLink Raven XE HSPA User Guide
46
Figure 6-4: HyperTerminal : connected
a. If you are prompted for a password, enter the default password 12345.
Tip:
You will not be prompted for a password if you connect using a COM port.
b. Type AT and press Enter. You should get a reply of "OK" or "0".
c. To see what you are typing as you type it, you will need to turn on the
echo and verbose mode. Type ATE1V1 and press Enter.
d. If you get a reply of "OK", then you entered the command successfully. If
you get a reply of "0" or "ERROR", try entering the command again.
20080616