Assembling The Main Saw Bench - Axminster 200387 User Manual

Assembling the Main Saw Bench...

W
A X M I N S T E R
W H I T E
Having unpacked the boxes, (please dispose of any unwanted packaging responsibly), put
the parts and components whereby they are readily to hand. Break down the main box by
knocking the sides away (be careful of exposed nails etc.), but leave the machine sitting on
its pallet. (See fig 1). Identify the short rear panel with the dust extraction cutout, locate the
dust extraction moulding and fit to the panel using the nuts and bolts provided. (See fig 3)
(The orientation of the moulding should leave the 30mm outlet pointing upwards i.e.
pointing up the long length of the panel).
Put the panel aside, and locate the remaining three panels, the lower chassis legs and 20
No. M8x20mm bolts, nuts and double washers. Fix the lower legs to the upper legs using a
washered bolt through the legs and secure with washer and nut, only turn the nuts up
finger tight at this time. (See figs 2 & 2a) Take up the rear panel with the dust extraction
moulding fitted and fit between the rear legs, using washered bolt through the leg and panel
and securing with washer and nut. Again, secure the nuts finger tight only. With easy open
access, now is a good time to fit the dust extraction hose. Locate the hose and the two large
jubilee clips. Stretch the hose out to its full length. Slip the jubilee clips over the ends of the
hose, fit the hose to the outlet on the saw box and the dust extraction moulding and clamp
in place with the clips.(See fig 3)
Fit the remaining panels to the legs, using the same securing sequence. Wriggle, push, pull,
press, lever etc., the legs and the panels into the best alignment with the upper chassis and
tighten the nuts and bolts using the spanners provided. When
everything is tightened up, the machine can now be tipped over,
towards its blind face (as seen in fig 4) until it is resting on the pallet
with its legs on the floor. Lift the machine upright. (See fig 5)
Fig 1
10
Upper leg
www.axminster.co.uk
M8x20mm bolts, nuts
and double washers
Lower leg
Fig 2a
Fig 2