Axminster 200387 User Manual page 32

Identification & Description of the Saw Table...
W
A X M I N S T E R
W H I T E
Length stop
(See fig D)
Rear extension
table
(See figE)
Drive belt
tensioning
Illustration & Parts Description of the Saw...
Fig E
32
A 'flip over' blade that can be moved up and down the length of the
fence, and clamped in position. The distance from the blade can be set
against the tape decal.
The rear extension table consists of 5 pieces, the table itself, two
support brackets, and two clamping plates. The clamping plates fit
behind the faces of the two rear upper chassis legs. They have tapped
holes top and bottom to accept the fixing bolts fitted through the
brackets and the legs. The mounting brackets are symmetrical and can
be fitted either way 'up'. The fixing holes are elongated to allow the
height of the table to be adjusted to be in the same plane as the saw
table. The table is bolted to the brackets. It is set off the back of the
main table sufficiently to clear the rip fence rear clamping rail and allow
the clamping end of the rip fence to move freely past it.
See Maintenance Section.
support bracket
www.axminster.co.uk
Dust extraction
duct
Rear extraction
table