Assembling The Saw - Axminster AWHBS250N User Manual

Assembling the Saw...

W
A X M I N S T E R
W H I T E
Lift the saw on to the completed cabinet, and secure using the 4 No. M8x40 bolts. (Insert the bolts
through the base of the saw, through the floor stand and fit the washers and nuts on the underside).
The saw table can be fitted without removing the blade. However, if you would feel more comfortable
not having to manoeuvre the table around the blade, remove the blade by opening the top and bottom
covers, release the tension on the blade by backing off the tensioning knob (See fig 1), and remove
the blade, taking care as it is manoeuvred clear of the guides and the safety guards.
NOTE: If you are going to remove the blade, prior to this you must check, and if necessary, set the
lower blade guide assembly about the blade. The assembly is mounted in a small housing that is
bolted to the main frame. It is locked in position by a hex socket grub screw that is extremely difficult
to access when the table is fitted. Check that the assembly is set evenly about the blade.
When mounting the bandsaw, we strongly advise you get the
!
assistance of another person because of the weight.
WARNING
10
Step 4
Two Man lift