Table of Contents
Advertisement
Chapter 6 BIOS and System Setup
NOTE: In order to enable the CPU overheat protection feature, the
Power Management field should not be set to Disabled.
Video Off Method
This field defines the Video Off features. There are three options.
V/H SYNC + Blank
DPMS
Blank Screen
Video Off in Suspend
When enabled, the video is off in suspend mode. The default setting is
Yes.
Suspend Type
The settings for this field are Stop Grant (default) and PwrOn Suspend.
Modem Use IRQ
This field sets the IRQ used by the Modem. By default, the IRQ used is
3.
Suspend Mode
When enabled, and after the set time of system inactivity, all devices
except the CPU will be shut off.
HDD Power Down
When enabled, and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
Soft-Off by PWR-BTTN
This field defines the power-off mode when using an ATX power
supply. The Instant Off mode allows powering off immediately upon
pressing the power button. In the Delay 4 Sec mode, the system powers
off when the power button is pressed for more than four seconds or
enters the suspend mode when pressed for less than 4 seconds. The
default value is Instant Off.
Wake-Up by PCI Card
The settings for this field are Enabled and Disabled (default).
50
Default setting, blank the screen and turn
off vertical and horizontal scanning.
Allows the BIOS to control the video
display card if it supports the DPMS
feature.
This option only writes blanks to the video
buffer.
LI7WM User's Manual
Advertisement
Chapters
Table of Contents
