TMC LI7WM User Manual page 95

3-3. Install the thin I/O panel plate inside the case. Be careful not
to cut yourself in doing so. The thin metal plate has six protruding
clips that should be inserted to their respective hole on the back
panel.
3-4. Install the CPU retention module to the LI7WM motherboard.
3-5. Install the motherboard into the case.
3-6. Install the game port cable onto the motherboard (J17 header)
and screw the connector onto the case.
3-7. Install the power supply onto the case.
3-8. Remove the power supply top screw diagonally opposite the
corner of the case. This screw will be used to fix the riser card
metal support.
3-9. Insert the BL21PI Riser Card onto the motherboard. Screw
the card onto the riser card metal support.
3-10. Screw the metal support to the power supply. Use the screw
that was remove from the power supply as mentioned in 3-8.
3-9 Screw
the
riser
card to
the
metal
Back Panel
3-11. Screw the FDD plastic siding onto the left side of the floppy
disk drive. Refer to the figure on the next page. Note that the FDD
plastic siding has six holes on it while the HDD plastic siding has
two holes. Make sure to use the small-thread 'mm' screws for
the FDD and CD-ROM drives and use the big-thread 'inch'
screws for HDD drive to avoid damage to the drives.
3-12. Install the floppy disk drive into the front panel unit.
LI7WM User's Manual
Chapter 11 LI7WM and the Databook Case
3-8 Remove this
screw.
3-10 Screw here
to attach
the
riser
card
3-7 Install the
power
supply into
the
95