Video Off Method; Video Off After; Doze Mode; Standby Mode - TMC TI6NBF+ User Manual

Chapter 6 BIOS and System Setup
Video Off Option
This field determines the modes where video is turned off. By default, the
setting is Suspend -> Off.

Video Off Method

This field defines the Video Off features. There are three options.
V/H SYNC + Blank Default setting, blank the screen and turn off
vertical and horizontal scanning.
DPMS Allows the BIOS to control the video display card if it
supports the DPMS feature.
Blank Screen This option only writes blanks to the video buffer.

Soft-Off by PWR-BTTN

This field defines the power-off mode when using an ATX power supply.
The Instant-Off mode allows powering off immediately upon pressing
the power button. In the Delay 4 Sec mode, the system powers off when
the power button is pressed for more than four seconds or places the
system in a very low-power-usage state, with only enough circuitry
receiving power to detect power button activity when pressed for less
than 4 seconds. The default value is Instant-Off.

Doze Mode

When enabled, and after the set time of system inactivity, the CPU clock will
run at a slower speed while all other devices still operate at full speed.

Standby Mode

After the selected period of system inactivity, the fixed disk drive and the
video shut off while all other devices still operate at full speed.

Suspend Mode

When enabled, and after the set time of system inactivity, all devices
except the CPU will be shut off.

HDD Power Down

When enabled, and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.

Throttle Duty Cycle

When the system enters Doze mode, the CPU clock runs only part of the
time. You may select the percent of time that the clock runs.

PCI/VGA Active Monitor

When enabled, any video activity restarts the global timer for Standby
46 TI6NBF+ Pentium II/III ATX Motherboard User's Manual